Back to Base-ics

Following a work stopping benchtop accident in which I knocked the completed wheelhouse interior onto the floor I took some time off and tackled the display board for the stand. I cut a piece of red oak to size and routed the edge with a Roman ogee bit. I stained it with a dark mahogany from ZAR and sprayed several coats of clear lacquer to seal it. Light sanding with 1000 grit paper kept it smooth between coats. I'm very pleased with the results (note 1/72 Permit class project in the background).

With the display base looking good, the urge to work on the boat came back so I returned to the wheelhouse. The pieces that were knocked off were CA'd back in place. Then I fabbed a latching pin system to keep it in place on the hull.

First, a hole was drilled in the forward end through both the deck and exterior pieces, then the forward access hatch in the hull. This captured a pin that slides in to secure them all via friction.

To hold the aft end in place a brass rod was bent to slide into a hole cut in the upper hull. This captures the entire assembly and holds it down. The wheelhouse now fits snug and doesn't move yet is capable of being disassembled. This will allow replacement of D-cell batteries for the lights inside the hull.